黄冈电动伸缩门知名厂

什么是混凝土界面剂

What is a concrete interface agent

混凝土界面剂是一种聚合物改性水泥浆沙，它可以加强与基层的粘合力，使物体更加牢固，它还有例如耐热，防水，抗冻融性能强等特点。在日常生活中，我们的墙壁是不允许出现抹灰层空鼓，起壳的现象，而混凝土界面则能够很好的避免这些缺陷。它主要用于混凝土基层抹灰界面处理和大型砖块的表面处理。

The concrete interface agent is a kind of polymer modified cement paste sand. It can strengthen the adhesion force with the base and make the object more firm. It also has the characteristics of heat resistance, waterproof, strong freeze thaw resistance and so on. In daily life, we are not allowed to appear the wall plaster hollowing, peeling phenomenon, and concrete interface can well avoid these defects. It is mainly used for the surface treatment of the plastering interface of the concrete base and the surface treatment of large bricks.

既然混凝土界面剂有这么多的优点，在日常生活中我们又应该怎么去使用它呢？一般没有特殊要求的情况下，直接使用清水搅拌成厚糊状就可以使用了，但是要注意不要有生粉团。水与灰的比例大约在1:4.5左右，处理好后放置5分钟左右再使用，效果会更好。夏天的时候，温度高，应该先在墙面上湿润后，再上混凝土界面剂。

Since the concrete interface agent has so many advantages, how should we use it in our daily life? No special requirements, the direct use of water and stir the thick paste can be used, but be careful not to have the raw dough. The ratio of water to ash is about 1:4.5. After treatment, it can be used for 5 minutes or so. The effect will be better. In summer, the temperature is high, it should be wet after the wall, and then the concrete interface agent.

混凝土界面剂使用注意事项

Precautions for the use of concrete interface agents

1、在下雨天的时候，不能够使用混凝土界面剂，这样会影响混凝土界面剂的使用效果。施工的环境必须保持干燥，且环境的相对湿度要小于70%，要保持良好的通风环境。基面及环境的温度不低于+5度。建议在早上9点到11点，下午3点到5点左右的时间段。是比较合适的温度和环境。

1. In rainy days, the concrete interface agent can not be used, which will affect the use effect of the concrete interface agent. The construction environment must be kept dry, and the relative humidity of the environment should be less than 70%, and a good ventilation environment must be maintained. The temperature of the base surface and the environment is not less than +5 degrees. It is suggested that the period from 9 to 11 in the morning, from 3 to 5 in the afternoon. It is a suitable temperature and environment.

2、混凝土界面剂对基面也有一定的要求。首先，基面要是处于干净，不松动，没有灰尘，油脂，青苔，地毯胶等的情况。一旦基面有出现这些情况，很有可能导致混凝土界面剂的粘合情况不佳，没有完全发挥效果等问题。

2, the concrete interface agent also has certain requirements to the base surface. First, if the base surface is clean, not loose, there is no dust, oil, moss, carpet glue and so on. Once these conditions occur on the base surface, it is very likely that the adhesion of the concrete interface agent is not good, and it is not fully effective.

3、我们在做好以上的工作后，还应该做好对其的养护和成品的保护，那我们应该怎么做呢?我们要做好通风，环境的通风可以使混凝土粘合剂更好的发挥效果。然后，待浆料的表面变成灰黑色及实干，并且确认完全封闭基面后，才能展开后面的工作。

3, after we have done the above work, we should also protect the finished products and protect the finished products. Then how should we do it? We should do well in ventilation and ventilation in the environment, so that the concrete adhesive can play a better role. Then, the surface to paste into black and hard work, and make sure to completely closed surface, behind the work.

4、在混凝土界面剂的储存应该放置在阴凉通风的干燥处。在开启后，要及时使用。以免混凝土界面剂出现变质的情况。在一般情况下，混凝土界面剂的保质期在6个月左右。

4. The storage of the concrete interface agent should be placed in a cool, ventilated and dry place. When it is opened, use it in time. In order to avoid the deterioration of the concrete interface agent. In general, the shelf life of the concrete interface agent is about 6 months.

5、混凝土界面剂是一种胶粘剂，具有超强的粘合性，抗氧化性。我们使用时，一定要换上特地的衣服。一旦粘到，不容易清洗。

5. The concrete interface agent is a kind of adhesive with super adhesion and antioxidation. When we use it, we must change the special clothes. Once stuck, it is not easy to clean.

以上便是对混凝土界面剂怎么用和注意事项的介绍，希望可以帮助到大家。

The above is the concrete interface agent how to use and attention to the introduction, hope to help you.